 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| TFS199E.doc version 1.1 06.05.2003 VI TELEFILTER Measurement condition Ambient temperature: 23 C Input power level: 0 dBm Terminating impedances at fc *: input: output: Filter specification TFS 199 E 1/5 715 670 || -5,9 pF || -5,9 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS 199E is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae . The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 199 MHz without tolerance. The given values for the relative attenuation a rel and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data Insertion loss (Reference level) Nominal frequency Centre frequency 0,7 dB passband Relative attenuation fN ......... fN fN fN fN fN 0,3 0,5 0,6 0,7 MHz ....... MHz ....... MHz ....... MHz ....... ae typ. Value 6,5 dB max. Limit 7 dB fN fc PB 199 MHz 199 - MHz - fN 100 kHz a rel 0,1 MHz MHz MHz MHz MHz 0,4 18 37 39 55 465 25 dB dB dB dB dB ns max. min. min. min. min. 0,7 dB 10 27 36 45 dB dB dB dB ns dBm**) V fN 0,5 fN 0,6 fN 0,7 fN 80 Group delay variation in PB p-p Input power level Voltage between any two terminals Frequency inversion temperature (T o ) Temperature coefficient of frequency Tc f Operating temperature range Storage temperature range max. 700 max. max 18 10 2 C - 35 C .. + - 40 C.. + - 0,036 ppm/K - 85 90 C C *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team **) This power level is only allowed for short term operation (10% of the life time), the max. input power for continuous operation is max.10dBm only generated: checked / approved: TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS199E.doc version 1.1 06.05.2003 VI TELEFILTER Filter specification TFS 199 E 2/5 Construction and Pin Connection (All dimensions in mm) 13,31 0,20 TFS 199E R19 data code 1 2 3 4 5 6 7 8 9 10 input ground ground ground output output ground ground ground input year + week 2001 2002 2003 date code: N P R ... 1,00,2 1,910,2 7,620,2 200 matching circuit: C1 L2 LB-IN 1 5 LB-OUT L1 SAW 10 6 C3 1: 4 C2 L3 4:1 2,3,4,7,8,9 TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS199E.doc version 1.1 06.05.2003 VI TELEFILTER Stability Characteristics Filter specification TFS 199 E 3/5 After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 -55 C to 125C / 30 min. each / 10 cycles DIN IEC 68 part 2 - 14 Test N 2. Vibration: 3. Change of temperature: 4. Resistance to solder heat (reflow):reflow possible: twice max.; for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: DIN IEC 286 - 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer mm 1700 min 300 mm min 500 mm min 300 Tape (all dim en sions in mm ) W : 24 0,3 Po : 4 0,1 Do : 1,5 + 0,1 E : 1,75 0,1 F : 11,5 0,1 G (min) : 0,60 P2 : 2 0,1 P1 : 12 0,1 D1(min) : 1,5 Ao : 7,1 0,2 Bo : 13,9 0,2 Ct : 21,5 0,1 Po EMBOSSED CARR IER TAPE Do P2 E Ao F W D1 Ct Bo G P1 COVE R TAP E W2 Reel (all dimensions in mm): A : 330 24,40 +2,0 30,4 60 13 0,5/-0.2 A C N W1 : W2 (max) : N (min) C : : W1 The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape. Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right. TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS199E.doc version 1.1 06.05.2003 VI TELEFILTER Air reflow temperature conditions Filter specification TFS 199 E 4/5 1st and 2nd air reflow profile Name: Temperature: Time: pre-heating periods 150 C - 170 C 60 sec. - 90 sec. main-heating periods over 200 C 20 sec. - 25 sec. peak temperature 255 C 5 C Chip-mount air reflow profile 260 240 220 200 180 temperature / C 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 time / sec. 140 160 180 200 220 240 Table for temperature vs. time during the air reflow process Tolerance of temperatures: 5 C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS199E.doc version 1.1 06.05.2003 VI TELEFILTER History Version 1.0 1.1 Reason of Changes Filter specification TFS 199 E 5/5 Name Pfeiffer Pfeiffer Date 06.01.2003 06.05.2003 generate specification according to customer requirements typical values and terminating impedances added TELEFILTER GmbH Potsdamer Strae 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. |
Price & Availability of TFS199E
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |